In fact, this situation occurs due to a variety of reasons, and it may be caused by the use of dyes in the selection of inks. In fact, this is what we call the improper matching of pigments used by packaging tape manufacturers. The second problem is caused by the use of too many thinners, especially the poor miscibility of thinners and inks. In this case, bleeding will occur. Therefore, in order to reduce this The situation happens, so we need to pay attention to the production process. If the bleeding of the packing belt manufacturer is likely to cause the surface of the packing belt to be blurred, it must be cleaned up during production to reduce the occurrence of these problems in order to obtain better packing belt application results.
1. After the screw of the packing belt production line wears out, repair by special surfacing and anti-corrosion alloy method. The worn area of the strap is ground to a uniform size, and then the outer circle of the screw and the side of the thread are ground. The size of the outer diameter of the screw is generally larger than the new screw size, so as to compensate the amount of wear of the barrel, thereby maintaining the original designed radial clearance.
2. Of course, if the plating of the original chrome-plated packing belt screw is worn, it can of course be re-plated.
3. If abnormal damage occurs inside the packing belt production line, it can be inserted, but the inner diameter of the inserted sleeve must be appropriate.