1. The temperature of the hot head of the baler is too high or too low, the temperature of the hot head is too high, the temperature of the packer is not enough to melt and bond the packing belt, or the bonding is not strong, but the bandage is too high. The temperature is too high, especially the adhesive part of the semi-automatic packing belt is melted too much under high temperature melting, and the most effective bonding is not possible, only the packing bandage.
2. The quality of the packing belt, due to the different parameters of the packing machine during the packing process, such as tension, temperature, etc., the adjustment of the tightening force is adjusted according to the packing material quality. , The maximum load-bearing tightening force can be adjusted to adjust the parameters of the baler. If it is too high, the bandage will be broken.
3. The cutter or bonding station of the baler cannot operate normally. The cutter and the bonding station of the baler are the key to the bonding of the strapping belt. The gap between the two is too large to make the strapping belt intact. It will be bandaged after the packing is completed, so there is no adjustment part for the gap between the cutter and the iron. The main control method is to pay attention to maintenance, pay attention to the oil lubrication of the cutter of the packer, and control the progress of the tension spring. The spring tension cannot pull the bonding station smoothly into place, there will be a gap between the two, but the binding of the packing belt is not good, and the bandage failure occurs.
4. The tightening force is too large. The tightening force of the baler is adjusted according to the packing needs. If the tightening force is too large, it cannot be cooled and bonded smoothly after the bonding is completed, but it is also possible to pack bandages. It is recommended that if a product with a large pulling force is required to be packed, the tightening force is required to be large, and a packing belt with high strength and good quality is used for packing.
The above is the reason why the Shanxi baler has broken during the use, which causes the problem of breaking. If you have any other questions, please leave a message on my website, or directly call the contact number on the top of our website. You answer.