One: If the automatic packer does not return
1. Check if there are foreign objects in the upper and lower extensions. Possible cause: Loose foreign bodies in the upper and lower extensions or the countersunk screws that fix the belt guide are loose, and the packing belt is stuck. Therefore, you need to remove the upper station to remove foreign objects.
2. It is possible that the crossbar 635 bearing is broken. Improper adjustment of the balance position of the crossbar may easily cause the crossbar to rupture. It should be properly adjusted in accordance with the instructions.
3. May be improper backlash clearance. Because the retracting roller has the function of tightening the belt, when adjusting the gap of the retracting roller, the retracting roller should be mainly used, and the clearance of the retracting roller should be 0.05 to 0.1mm more than the thickness of the belt.
2: The bonding effect is not good
There are 8 reasons for poor adhesion. 1. The temperature adjustment knob is not adjusted properly. 2. The power supply voltage is abnormal. 3. The pull spring of the electric heating monster fails. 4. Improper adjustment of the position of the ironing head of the baler. 5. The middle knife bearing is broken. 6. The temperature inside the machine is too high. 7. The heat-resistant wire of the iron is faulty. 8. The tightening force of the baler is adjusted too much.
The circuit board of the automatic packer is broken
1. First check whether the relay is damaged.
2. Check whether the sensor head is damaged.
3. Check if the switch is faulty. If it can't solve it, please ask a professional to handle it.
Four. Cut off without binding
1. The tightening force may be too small, you need to increase the tightening force.
2. The cause may be improper LS3 or LS5. Countermeasure: Adjust the position of the micro switch
3. Possible cause: Damaged magnetron countermeasure: Replace magnetron
Other reasons: foreign body stuck
V. Cannot insert
1. LS3 Improper Position Countermeasure: Adjust the normal position. The front ejector of the baler is too high and cannot be inserted
2. The clutch clearance of the automatic packer is not adjusted properly. If it is too small, it will slip. If it is too small, it will not be clear. Countermeasure: Adjust the clutch clearance.
3. Possible cause: The LS1 position is faulty. Countermeasure: Replace the LS1 or adjust the shrapnel position.
Six. Continuous action of automatic packer
1. Possible cause: LS1 failure. Countermeasure: The micro switch is faulty or stuck. Replace or clean up foreign objects.
2. Possible cause: LS3 failure countermeasure: Replace the LS3 micro switch.
3. Possible cause: Circuit board failure countermeasures: Repair or replace the circuit board.
If the failure of your automatic baler cannot be ruled out, please contact Chuangnuo Packaging Co., Ltd